Anyone used this with a pro autodisc 2 with ball powders?
I'm thinking about it, and have seen it somewhere.
From the post I saw
I think I'll try it
No, chargebar will only fit on top of disk due to index pins on the bottom of the disk. But the problem you'll run into is inconsistent powder drops as the adjustablechargebar will be loose on top of the disk and larger than disk hole setting on the chargebar will keep some powder on top of the disk hole.
For me, a better solution came from stacking two charge bars. With slight filing of the index tabs, I was able to make a tight fitting stack that provided much greater powder drop capacities than two largest disk holes (I metered up to around 47 grains of I4895/H4895/Varget and 48 grains of RL15 and I didn't even max out the adjustments).
Yellow arrows show filing points
![]()