I have a question, does the coating stay on well enough to prevent getting lead in your suppressor/silencer ?
Likes: 51
Dislikes: 0
I have a question, does the coating stay on well enough to prevent getting lead in your suppressor/silencer ?
Luck is the phenomena created when Preparation meets Opportunity .
On the bullets I’m using I would say no. I haven’t shot any through my suppressor but the flash hider on my 9mm AR had a good amount of lead built up in the holes. I never had barrel leading issues though.
best not to mix up your hard-on boolits with others should you need to defend yourself from an attacker....Originally Posted by Cattle/Horses
Could be a new depth to the saying "shooting blanks".
5G Motorola Razr
Well, a mold mallet and some lee molds showed up.
I'm still reading..I found a bottom pour pot I didn't know I had..getting a bit closer
782554.jpg
994155.jpg
Last edited by mapper; December 28th, 2020 at 08:11 PM.
Mapper, let me be the first to place my order for some 325 to 350 grain 44 magnum bullets. 1000 - 2000 would be good
5G Motorola Razr
C/H, I think you have me confused with Donnie Miculek.
They are 12-14 week backlog..
I'm just trying to expand my recycling skills..
Last edited by mapper; December 28th, 2020 at 09:15 PM.
Just always looking for new sources. Hope springs eternal. lol
5G Motorola Razr
Mapper, pay close attention to the instructions when they talk about smoking the molds. Those lee molds require a little deferent process than cast iron molds.
Luck is the phenomena created when Preparation meets Opportunity .
Will do, thanks.
I would expect aluminum molds behave a bit different than steel ones, I've seen suggestions to heat them with the sprue plate down, due to different thermal properties of the steel and aluminum. It's all going to be a learning curve. I have some lyman or ideal molds as well..I just wanted a round profile to start with
Posting Permissions
Reply With Quote