New folks to the craft in out of stock world

[WinterSoldier]

Do people still use wheel weights? I may have a few pounds around if they're any good.

Wheel weights are good for smokeless handgun loads, so long as they are actually LEAD. If you get one or two of the alloy ones in the pot you've ruined your bullets.

But, BTW. I only got into lubrisizers after I moved more towards black powder, so I mostly use them for black powder soft lead (pure or near-pure lead) bullets. For smokeless I prefer the Lee Precision sizers and a Lee (or other) alox bath. My 9x18mm hand loads using cut-down 9mm Parabellum brass and wheel weight lead bullets lubed with alox consistently cut my group sizes by at least half of anything Russian commercial ammunition can do for me... and the burning powder smells a lot nicer too... not to mention not propping-up Putin.

[WinterSoldier]

But... I've got a 120 grain lead bullet that I make in soft lead from a mold I designed for two very different uses... For a 9x18mm a bullet of that weight has to be very short and blunt... almost a ball. I couldn't make the mould with as large of a grease groove as I would have liked but I prefer lubrisizer lubrication for those, because I also use the same bullet in Pietta .36 cal. Remington 1858 revolver reproductions. Pietta for reasons unknown to the sane parts of society uses a rifle twist in that handgun and it's NOT a fast enough twist to stabilize ANY commercially available lead bullet that I know of. It WILL, however, stabilize the bullets that I designed quite nicely. And, for black powder, I want a beeswax-based natural lubricant, not petroleum, which gums up from black powder fouling.