Signal 0
Likes Likes:  10
Dislikes Dislikes:  0
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: 9mm stepped brass, scrap it.

  1. #11
    Graduate
    Join Date
    Aug 2012
    Posts
    3,100
    I can't imagine a standard die with a decap stem, size ball and pin not having problems when it hits that step.

    Not counting reduced case capacity and concerns about separation and bullet length.

    Just does not seem worth it to me save 3 cents on brass cost, and have additional issues that you don't have in standard brass.

  2. #12
    CCGF Depository Dale Gribble's Avatar
    Join Date
    May 2012
    Posts
    14,859
    Quote Originally Posted by mapper View Post
    I can't imagine a standard die with a decap stem, size ball and pin not having problems when it hits that step.

    Not counting reduced case capacity and concerns about separation and bullet length.

    Just does not seem worth it to me save 3 cents on brass cost, and have additional issues that you don't have in standard brass.
    I use a universal decapping die, it wouldn't even notice. And I don't think the expander on my sizing die goes down that far into the brass.
    When I despair, I remember that all through history the ways of truth and love have always won. There have been tyrants, and murderers, and for a time they can seem invincible, but in the end they always fall. Think of it--always.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •