Signal 0
Likes Likes:  4
Dislikes Dislikes:  0
Page 2 of 2 FirstFirst 12
Results 11 to 11 of 11

Thread: Anyone have a program for load development

  1. #11
    Graduate
    Join Date
    Aug 2012
    Posts
    3,100
    I asked a friend to do a run in quickload for a 7 rem magnum and 150 and 160 sierra game kings And reloder 33.

    This was the output he sent me.
    This was his notes:
    ran with stock capacity if you got me his case capacity i could get you closer. r33 is a slow powder so i don't think you can get enough in the case to blow anything up. take note to the fill percent they will be compressed loads



    So it looks like a good tool, I have seen other runs in diffrent calibers help to give a insight on usable powders.

    http://www.neconos.com/item/QuickLOA...Software-V39-3


    There is also a program where you can design cases, and use numbers from that as well, I haven't seen any output though.

    http://www.neconos.com/item/QuickDES...ign-Program-88
    Last edited by mapper; February 12th, 2017 at 12:22 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •