PDA

View Full Version : IMR 4007SSC powder recall information



Dale Gribble
September 2nd, 2015, 02:14 PM
PRODUCT SAFETY WARNING AND RECALL NOTICE FOR IMRŽ4007SSC POWDER
Shawnee KS, September 2, 2015 IMR Legendary Powders is officially announcing a product safety warning and recall notice for IMR 4007SSC on the six lot numbers listed below. IMR has received reports that this particular powder in 1lb and 8lb containers may have become unstable due to possible rapid deterioration. Use of this product from these lot numbers shown on the back label may result in spontaneous combustion, fire damage or possible serious injury.
LOT Numbers:
10130139, 10131139, 10429139, 10430139,80425139,80426139
What to do:
1. Stop using this product immediately! Fill the powder container with water which will render the product inert and safe for disposal.
2. Mail, email or fax a copy of the powder label showing the lot number to the contact information below to include your name, address, phone and email.
3. Replacement choice of any other IMR smokeless powder product will be shipped to you for no charge.
4. If you have loaded the powder subject to this recall into ammunition, we recommend that you pull the bullets, remove the powder and wet the powder with water for safe disposal.
IMR deeply regrets any inconvenience this may cause, but we believe in safety first.
For more information: visit imrpowder.com, IMR Powder Company, 6430 Vista Drive, Shawnee, KS 66218, email help@imrpowder.com , call 913-362-9455/800-622-4366 or fax 913-362-1307

Bodo
September 2nd, 2015, 02:25 PM
Spontaneous Combustion. How exciting!

Airgator0470
September 2nd, 2015, 04:50 PM
I have just over 2 pounds left, not effected. This powder has been discontinued and last I spoke with IMR they were going to release just one more batch. Shame... works great in my 6.5 CM LR-65.

polebarn
August 20th, 2020, 11:30 AM
Apparently all lots were affected.

https://www.ssusa.org/articles/2019/10/25/recall-notice-imr-4007-ssc-powder/

Airgator0470
August 21st, 2020, 08:01 PM
UPDATE... since my last post above I loaded a little over 300 rounds 6.5C and .308, all of it is ruined. I hadn't looked at it since storing it in my gun room, pulled some out this week to shoot and found this...

https://imagizer.imageshack.com/v2/640x480q90/922/cpTPM9.jpg (https://imageshack.com/i/pmcpTPM9j)

Tried pulling down rounds that showed to outward signs of corrosion but inside the case was fubar. When I pulled the bullets you can hear a popping sound, gas build up indide the case no doubt.

Cattle/Horses
August 21st, 2020, 08:12 PM
Thanks for posting the pic AG.

Airgator0470
September 7th, 2020, 09:38 PM
Pulled all the bullets, cleaned them, they will do for range fodder. Tossed the powder and primers.

The brass, toast for the most part. In an effort to prevent anyone from loading the brass I used wire cutters to crush the necks. Some of the brass was do deteriorated, the brass easily tore/broke with minimal pressure. The insides of most cases were severely corroded.